![]() Attach the charger to the bracket with the clips and tighten in 4 screws – 2 on top and 2 on bottom.After checking that (your electrician will know what numbers you need), turn the breakers back OFF. Now, it’s time to turn on the breakers and check the electricity output.Run the wires into the labeled holes, and tighten the screws.To attach it to the Tesla charger part, you’ll need a 5/32 drill bit to unscrew the 3 holes where the wires will go into.Again, make sure nothing is on with you do this, and nothing is loose when you tighten. Then do the same for the live wires, except these will go inside the breaker amps you just attached.Measure, cut, and strip the wire, then putting it in the slot and tighten down with a screwdriver. Attach a 60 amp breaker to the breaker slots.The wires we use already have a slippery coating on them, making them really easy to run. Simply, attach the wires to a wire feeder with electrical tape and pull through. We use 1 green for ground and 2 reds for live wires, but you can choose whatever colors you want. Once the back of the charger is drilled into the wall, we start running wire through.Once you get to the end, cut the pipe cleanly and attach an elbow pipe and a bracket on top to connect to the charger from the bottom.We got PVC 3/4 inch pipe and brackets that are bigger than the pipe to make room for contracting and expanding. ![]() We attach pipe from there to about 25 feet down the siding of the house to where we will mount the charger. Punch one of them out to run the wire through later.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |